World's Largest, most contemporary Safety Banners Selection . . . . from the World's Largest safety banner manufacturer.
Strong & Outdoor Grade - Quality Safety Banners

See All Standard Vinyl Banners

Digital Banners - We are one of the largest digital banner manufacturers in the U.S. producing thousands of banners a year. We have had safety banners survive hurricanes Katrina, Gustav and Ike. That is how strong our material is.

Important Points to Understand:

A - Material "Weight" does NOT equal material strength. Most of the LARGE, high end banner manufactures use 10 oz. or 11 oz. tight weave reinforced vinyl material from high end leading material manufacturers with high quality standards. The tighter the reinforcing nylon weave, the stronger the banner. 13 oz. banners have a "loose" weave, are less costly to produce and actually cost less than the tight weave 11 oz. material SafetyBanners.Org uses. We have had banners survive Hurricanes Katrina, Gustav and Ike. That is how strong our material is.
B - Print Quality diminishes as the "weight" of the reinforced vinyl material increases and more of the nylon cord "checker boarding" shows up. 10 and 11 oz. tight weave material yields the best print image quality.
C - Resolution does NOT equal image quality. In the digital world, using the word "resolution" to define print quality is like using "nearby" to define a specific distance. In Alaska, nearby is about 100 miles. Typically, smaller digital printers use resolution because they do not have or understand the technology and other equipment necessary to truly manufacture a true high quality banner. There many many OTHER factors involved in printing a high quality.
D - High Volume Production allows reduced prices and very high quality standards. SafetyBanners.Org manufactures more banners than our four largest safety banner competitors combined.
E - Blockout material is used for Two Sided banners and is not at all necessary to print a One Sided banner, has a lower "strength" rating than the tight weave high quality 11 oz. reinforced vinyl that SafetyBanners.Org uses, adds unnecessary cost to the banner and makes the banner MUCH heavier in actual weight and thus more difficult to install.
F - Banner Longevity is a combination of high quality INK, high quality MATERIAL and state-of-the-art printing technology. If any one of those three elements are lacking, the banner longevity is significantly reduced. SafetyBanners.Org banners are guaranteed for a full 5 years.
G - Manufacturer history is also important. New Tech Graphics, the home of SafetyBanners.Org has been printing digital banners since 1994, longer than over 95% of the digital banner printers now in existence.
H - Call us with Questions - 901-759-0932, or email us at jmetz@newtechgraphics.com with ANY questions you have.

Request materials sample pack be mailed to you. Just put "Sample Request" in the Subject with your Name and Address in the body of your email. We will send it out the next business.

Our Safety Banners use only premium outdoor grade, strong, tight weave nylon reinforced vinyl that will last 5 to 7 years OUTDOORS and 20 years indoors - GUARANTEED. All our safety awareness banners are fully hemmed with reinforced grommet holes at each corner and in the center. Our industrial safety awareness banners are fully fade resistant weather proof so you can use them both outdoors and indoors with confidence. Nobody produces higher quality work place safety banners for your safety awareness program than SafetyBanners.Org - nobody.

Our Banners come in 6 Sizes:
• 3' x 6'
• 4' x 8'
• 5' x 10'
• 6' x 12'
• 8' x 16'
• 10' x 20'
• If you need larger, call us - 901-759-0932, We can go as large as 150' x 300'.

Would you pay $198 for these banners?? $198 plastic banners designed in the 80's. Not in this century you wouldn't!

Are you a VPP Site?? Do you use VPP Banners and VP Posters?? Check out our VPP Page.

Safety Banners are highly visible, but need to be designed by professionals with the impact on the viewer in mind. Most of the safety banners are low impact, uninteresting and visually lacking. This is because most companies do not have the capability and equipment to produce stunning graphics and imagery like we do. Furthermore, most of the designs come from the 80' and 90' and suppliers have failed to update their safety banner designs and make them more contemporary. SafetyBanners.org has trained professional designers on staff who design all our products! It is almost an insult to your employees to put up a banner with stick-like figures or clip art from the 80's and expect them to pay any attention to it. We have been told time and time again that our safety banners have much more impact than our competition and actually do help increase safety awareness. Cost is always a consideration. We can be a low cost leader in graphic safety product because our entire company is focused on digital graphics for safety and retail stores and are one of the largest companies in our industry.

We add new safety awareness banners monthly, so check back often to see what new we have to offer. The Recently Added Category, will have all the safety awareness images and safety banners we have added in the past month. Industrial safety Banners for industry safety awareness programs are becoming recognized as the BEST way to increase safety awareness with both the employees and management. OSHA, and it's VPP program, recommend safety awareness promotion using banners. We are here to help. When you call, you will talk to real people and get real answers. Our founder always said, "We are really in the customer service business. We just happen to also sell work place safety banners." Thank you for your visit here and your time. We appreciate it.

Our Very First Safety Banner

Safety Banner Information and Tips

 

How Many Colors can my Custom Banner Be?:

 

Unlimited! We have ZERO color limitations because we actually PRINT your safety banner. We have seven banner printers very similar to the little color printer on your computer. The main difference is ours cost over $100,000 each and are 12 feet wide.

           

 

Hanging a Safety Banner:

 

All our safety banners come with at least six rust-proof brass grommets to make installation and hanging easy. See the graphic below to determine how many grommets your banner will have (they vary by size). For installation on an interior or shelter wall, merely pin the banner to the wall using the grommet holes. As an alternative, you may even drive a pin or nail through the hemline. When using twine or rope, attach the ropes on the top two corners and stretch the banner out to make it look great.

 

When hanging a safety banner from the ceiling, be sure to pull the corners tight so the banner does not sag in the middle. If it does, you might want to attach a third rope to the center grommet to hold the center up properly.

 

Dowel Rod Top Alternative for Ceiling Hanging Banners

 

For a small additional fee, we can hem in a stiff 5/8’s inch dowel rod into the top hem of the banner and place a grommet hole in each top corner. With this method, you can hang the banner from each corner and be assured your safety banner will not sag in the middle and hang straight. (up to TWELVE FEET MAXIMUM)

 

 

Hanging a Safety Banner Outside:

 

OUTSIDE Safety Banners MUST be hung taught!

 

The key to hanging any banner outside it hanging the banner TIGHT. Even calm areas of the U.S. occasionally get windy conditions. What destroys an outside banner (even the ultra heavy 16 and 19 oz. tent banner material) is the flapping vibration that happens during any windy time. This flapping vibration will soon rip out ANY grommet on ANY banner. Once one grommet is ripped, even just a bit, it is not long before other grommets are ripped and the whole banner is destroyed. This can happen in just hours.

 

OUTSIDE Safety Banners MUST be hung taught! Stretch the banner tight by all four corners and the center grommets if possible. A tightly hung banner will have a much better chance of surviving the wind when it strikes.

 

 

Windy Conditions and Fences:

 

First, SafetyBanner.Org produces a product called “Mesh Fence Banners”. This material has small perforations in the material to allow wind to pass through and is designed specifically for windy conditions. We ALWAYS recommend this product. A standard vinyl banner may not last long in windy conditions.

 

All outdoor safety banners must be hung taught. Mesh Safety Banners MUST be hung taught using ALL the grommets on the banner if possible! Stretch the banner tight by all four corners and ALL the grommets if you can. For a MESH FENCE SAFETY BANNER on a fence, after stretching the four corners to make the banner tight, use strapping ties to attach all the other grommet holes to the fence. A properly hung banner will have a much better chance of surviving the wind when it strikes.

 

Wind Slits: Wind slits were invented in the 1960’s long before Mesh Fence Banner material was developed. For Wind slits to have the same wind release as mesh fence banner material, you need to place one wind slit every 3 square feet! This means that a 4’ x 8’ banner needs at least TEN WIND SLITS to be effective. We believe wind slits make a good-looking banner ugly and we rarely use them on a banner.

                       

 

How Large Should my Safety Banner Be:

 

Size Does Matter. A 3-foot x 6-foot banner looks big from 15 feet, but inside a cavernous facility, it may look rather small. Our returning customers, who first purchase 3’ x 6’ banners, often purchase larger ones because the small sizes can look really small from a distance, like the center of a large facility. Remember, we can go as large at 10-foot by 20-foot with our standard designs. We can even produce a banner as large as 40-foot by 80-foot if you need one.

 

There is not real standard for safety banners, but we do have a suggestion that may help you decide. Have a pair of co-workers stand about 12 feet apart in your facility. Now step back to a distance from where you want your banner to be easily read and viewed. Essentially, you are looking at a 6-foot tall by 12-foot wide banner. (Unless you employ a large number of basketball players.) A 3-foot by 6-foot banner would be about half that size (waist high and half the width). What do you think?? 3-foot by 6-foot not a big as you thought? We know. Interesting isn’t it.

 

 

How Long Will my Safety Banner last?

 

The answer varies. Indoors, in a sheltered area, about 75 to 100 years. Totally exposed to the elements all day long in the middle of Death Valley, about 18 months. In a Category 3 Hurricane? We have had banners survive Katrina and Gustav.

 

ALL our safety banners are Premium Grade, Nylon Reinforced Vinyl designed to be used Outdoor and Inside. The keys are:

A.) How they are hung (see hanging a safety banner outside above)

B.) Where they are used (inside, outside, high wind, intense desert heat, etc.

C.) Where you live – Minnesota, Nevada, Louisiana and so on.

 

Here is the SafetyBanners.Org Guarantee. If you are not happy with our banners, we will take care of you – Period. Our customers are our most valuable asset and we will do what ever it takes to protect this asset – YOU! No body in our industry has a guarantee like that.

 

 

Horizontal and Vertical Safety Banners:

 

Horizontal – Vertical – we do BOTH. SafetyBaners.Org is the ONLY safety banner manufacturer that offers ANY BANNER in BOTH Horizontal AND Vertical Format.

 

Horizontal banners are generally more popular, because most facilities have wider hanging spaces and limited vertical hanging space due to forklift traffic, etc. However, Vertical banners often are great when you have a very high ceiling and want the message to hang lower, want to hang on a wall and get the message down to eye level, or just want to break up the horizontal lines of most facilities which makes a vertical banner jump out more and get attention where a horizontal banner may not.

 

In late 2005, our founder noticed that most of the workplace safety banners on the market for industry safety awareness programs were generally drab, only two or three colors, unimaginative and over priced. With over 20 years in the retail point-of-purchase business where images were exciting, vibrant and eye catching, he thought we could do a better job. He was right. In less than one year, we went from one safety banner, to the absolute U. S. leader in safety banners doing business with the majority of the fortune 500 companies. For that, we thank our wonderful customers.

Please Note: safetybanners.com, safetybanner.com and mysafetysign.com is a label and decal company that also sells banners and is NOT us. We are safetybanners.org. We offer an unparalleled quality and selection of contemporary safety banners - safetybanners.org.

Need Help?? Call us --- 901-759-0932 --- SafetyBanners.org, manufacturers of High Impact Safety Banners and safety awareness products to Promote On The Job Safety. All images and designs are the property of New Tech Graphics and may not be reproduced without written permission. Manufactured on demand by New Tech Graphics - located in MEMPHIS, Tennessee, the Heart & Soul of Rock & Roll.
SafetyBanners.org is a subsidiary of New Tech Graphics.